How far should a clamp be connected to a PV module?

Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load. *Note: The above-described distance is from the module edge to the middle of the clamp.

What is a solar module clamp?

Module Clamps are Type 304 stainless steel for higher yield strength and durability. Pre-assembled module clamps feature no loose parts and a spacer that keeps free standing clamps in place for a quicker module installation. Patented. Note: Replace xxx with module depth from the Solar Module Specification Sheet.

How do I install a double glass PV module?

Insert the PV module into the clamp, and make sure the module edge touch to the EPDM closely and then tighten the nut with uniform torque values using a qualified torque wrench to ensure the double glass module is firmly secured. Trina suggests using M8 bolts to affix the double glass modules onto the clamp.

What is a module clamp?

See Assembly Instructions. Module Clamps are Type 304 stainless steel for higher yield strength and durability. Pre-assembled module clamps feature no loose parts and a spacer that keeps free standing clamps in place for a quicker module installation.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

How to install Trina Solar module with frameless clamps?

Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load.