How do I install a solar photovoltaic system?

Installing solar photovoltaic systems requires specialized skills and knowledge. Installation should only be performed by qualified personnel. Before installing a solar photovoltaic system, installers should familiarize themselves with its mechanical and electrical requirements.

Where should Trina Solar PV modules be installed?

In most applications, Trina Solar PV modules should be installed in a location where they will receive maximum sunlight throughout the year. Modules should not be shaded by buildings, trees, chimney, etc. at any time of the day. Do not install in corrosive environments, such as beaches or landfill that can be easily flooded.

How to install a photovoltaic light fixture?

The fixture shall be installed within the scope authorized by Suntech. The inside side of the fixture and the side of the photovoltaic module should be completely fitted. In any fixture installation mode, the fixture must not touch the glass or deform the frame of the bracket or module.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

Who should install solar photovoltaic systems?

Installing solar photovoltaic systems require specialized skills and knowledge. Installation should be performed only by qualified persons. Installers should assume the risk of all injuries that might occur during installation, such as electric shock.

How to install Trina Solar module with frameless clamps?

Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load.