What is a power storage manual?

About This Manual This manual describes the transportation and storage, mechanical installation, electrical connection, power-on and power-off operation, troubleshooting, and maintenance of the ESS. Target Group This manual is for operators of the power storage plant and qualified technical personnel.

How do I start the energy storage system ChS2 series?

CHS2 Series 6.1 Start Up and Shut Down the Energy Storage System 6.1.1 Start Up Step 1: Turn ON the DC switch on the inverter. Step 2: Turn on the AC Circuit Breaker. Step 3: Rotate the Main Switch to ON position.

When should ESS be set to 100% battery capacity?

When utility grid failures are extremely rare, it could be set to 100%. In locations where grid failure is common, or even a daily occurrence, such as in some African countries, you might choose to use just 20% of battery capacity and save 80% for the next grid failure. ESS can also be configured to keep the batteries fully charged.

How do I use ESS battery life?

Connect to AC when available, keep batteries charged: Use ESS Assistant and select the “Keep batteries charged” mode. • Not available in the ESS System yet, but it will be implemented. The ESS BatteryLife feature will make sure that the batteries are not unnecessarily cycled around a low SoC.

What does ESS 'inverter AC output in use' do?

This setting allows ESS only to use battery power for essential loads. It also allows battery banks to be sized to get critical loads through the night without the battery being discharged into the non-essential loads. This menu item is only visible if 'Inverter AC output in use' is enabled. 4.3.5. Feed-in excess solar charger power

How do I set up an ESS system?

There are a few different ways to set an ESS system up. A combination of these are possible as well: See below drawings to get an idea of all possibilities. The first drawing shows the wiring when a MultiPlus-II is used; and the second one shows how it is wired with a MultiPlus or Quattro.