Where should a generator be installed?

CODES MAY REGULATE THE DISTANCE AND LOCATION. The generator must be installed on a level surface. The generator must be level within a 0.5 in (13 mm) all around. The generator is typically placed on pea gravel, compacted soil, crushed stone, or a concrete pad. Check local codes to see what type is required.

How do you install a generator on a used engine?

Note: When installing a generator to a used engine, remove the flywheel and visually inspect the rear crankshaft seal for any sign of oil leakage, and replace the seal if needed. After replacement of the flywheel, check it with dial indicator to insure it is installed correctly and running true.

How do you install a generator drive plate?

Slowly move the generator drive plates onto the studs until the plates bottom in the flywheel. When the plates are bottomed put two bolts in the generator flange outer circle of bolts (only finger tight). Next remove the line-up studs and begin nstalling the drive plate bolts, again finger tight, one at a time, until they are all installed.

How do I set up a generator?

Install 7.5A fuse in controller. Confirm the generator MLCB (generator disconnect) is OFF (OPEN). At the controller, set the generator to AUTO mode. Generator will start and run. Allow generator to run and warm up for a few minutes. Set the MLCB (generator disconnect) to ON (CLOSED). Set the main utility disconnect to ON (CLOSED).

How do I install a generator hook-up?

A licensed electrician should perform a generator hook-up installation, but here are the general steps involved in the installation. Call the local utility company to shut off the power to the panel. They’ll pull the meter and then test it to ensure there is no power feeding the panel from the utility company.

How do you attach a front adapter to a generator?

Every generator maker has a method for attaching the front adapter to the generator. In the case of this Marathon unit, there is a clever system of dogs that allow quick adapter change. All it takes to bolt on the adapter is replacement of the dogs and their bolts after the new adapter is in place.